Jekk it-tank tat-taħlit idur lejn l-arloġġ jew kontra l-arloġġ jiddependi fuq id-disinn. Jekk id-disinn ma jkollux marka tat-tidwir, huwa possibbli li ddawwar ix-xellug u l-lemin. L-isteering tar-reducer huwa ġeneralment possibbli mix-xellug għal-lemin. L-isteering tiegħu jiddependi fuq it-tip ta 'xafra li tħawwad, u d-direzzjoni (minn l-arloġġ jew kontra l-arloġġ) għandha tingħata fid-disinn ġenerali.
Ir-rotazzjoni tal-ħawwad ma tistax tinbidel b'mod każwali, minħabba li f'xi każijiet, il-paddle tat-taħwid huwa msakkar fuq ix-xaft tat-taħwid b'ġewż tal-qfil, u d-direzzjoni tar-rotazzjoni hija ġeneralment opposta għad-direzzjoni tal-ħajta. L-isteering tax-xaft tal-output tar-reducer għandu jkun l-istess bħall-isteering tat-tagħmir, sabiex l-istering tax-xaft tal-input jista 'jiġi determinat, u b'hekk jiġi ddeterminat l-isteering tal-mutur. Jekk ikun hemm direzzjoni ta 'rotazzjoni li tħawwad fuq ir-reducer tal-mutur li tħawwad, skont ir-regolamenti tar-reducer, id-disinn tal-proċess għandu wkoll jissodisfa r-rekwiżiti tat-tagħmir. Ladarba jintgħażel l-aġitatur tat-tank tat-taħlit, id-direzzjoni tar-rotazzjoni tiegħu hija ffissata u ma tistax tinbidel b'mod arbitrarju.
Stirring container standard: Generally, the turning direction of the stirring shaft should be indicated in the drawing. If forward and reverse rotation is really required, it should be indicated in the technical requirements, and the rotational speed should be specified. However, this is not the case in the actual process. The direction of rotation (normal operation) is indicated in the drawings, for example, the direction of rotation is indicated in the drawings. However, there may be instantaneous or intermittent reversal (abnormal operation) in the actual process. Generally, the speed of reversal is relatively slow and the time is relatively short, so it is not considered, and the strength of the spoiler needs to be calculated. There are also many problems encountered in the actual process. When the motor or process does not support reversal, it will be indicated in the technical requirements that "the rotation direction of the stirring shaft should be consistent with the illustration, and should not be reversed".
